FARWEST PAINT PRODUCT INFORMATION

Interior Finish Coatings

#300 Series Semi-Gloss Alkyd Enamel

(#300 White/#310 Deep/#315 Ultra Deep/X-5854 Clear)

COLOR(S): White and Tints.

PRODUCT TYPE: Pigmented Semi-Gloss Alkyd Enamel

DESCRIPTION: A versatile top quality alkyd enamel. It is a durable, washable finish for bathroom and kitchen walls, millwork, cabinets, trim and furniture. Outside it may be used for sash, body, trim, gutters, etc. where a high gloss is not desired. It will not absorb dirt and is easily washed with any good detergent or paint cleaner. As a marine enamel, it may be used on hulls and topside. This high quality enamel has been sold successfully to the Federal Government meeting military specification TT-E-508. It covers exceptionally well and does not show shiners or flat spots.

Intended Use: For bathroom or kitchen walls, millwork, cabinets, trim, furniture, or as a marine enamel.

PHYSICAL CHARACTERISTICS

VISCOSITY: 84 k.u.

DRY TO TOUCH: 2 hours

WEIGHT SOLIDS: 71-74%

TACK FREE: 5-6 hours

VOLUME SOLIDS: 53-59%

TIME TO RECOAT: Overnight

WEIGHT PER GALLON: 10.10-11.30 lbs. per gal.

DRY HARD: 8 hours

V.O.C.: 338 grams per liter

COLOR RANGE: White and Tints

FLASH POINT: 105 F.

PACKAGING: 1 or 5 gallon containers

BATCH: Stock

PRACTICAL COVERAGE: 300-600 square feet per gallon depending on surface to be coated and application.

SURFACE PREPARATION: Surface must be clean, dry, properly prepared and free of all foreign agents and loose particles. Previously-painted glossy surfaces should be dulled with sandpaper or Farwest #644 Gloss Set (Liquid Sandpaper). A coat of Farwest #721 Wonderglo Enamel Undercoat for woodwork is recommended, but if the surface is in good condition, one coat of semi-gloss gives very satisfactory results. NEW WOODWORK, FURNITURE OR CABINETS: Putty all holes or deflections and sand lightly; then apply one coat of Farwest #721 Enamel Undercoat. When completely dry, apply the finish coat. FOR PLASTER: Apply one coat of Farwest #706 E-Z -Seal Wall Sealer. FOR NEW WALLBOARD: Prime with Farwest #970 Poroseal PVA Primer Sealer. When primer is thoroughly dry, apply Wonderglo Semi-Gloss Enamel.

APPLICATION: Apply by either brush or roller.

THINNING: Thinning is not recommended but, if necessary, thin with Farwest #602 Mineral Spirits.

CLEAN-UP: Tools and equipment may be cleaned with Farwest #602 Mineral Spirits.

LIMITED WARRANTY. To the best of our knowledge, the technical data presented above is true and accurate at the date of issuance and subject to change without prior notice. Farwest Paint Manufacturing Co. guarantees its products to conform to its standards of quality control. Liability is limited to replacement of product. No other warranty or guarantee of any kind is made by Farwest Paint Manufacturing, implied or otherwise.