FARWEST PAINT PRODUCT INFORMATION
Marine Protective Coatings
MATSON #40280 Series Rapid-Dry Gloss
(#40280 White Base/#40281 Deep Base/#40282 Clear Base)
COLOR(S): Bases: White, Deep, and Clear For All Colors.
PRODUCT TYPE: Acrylic Modified Fast-Drying Alkyd Enamel.
DESCRIPTION: A quality, fast-drying high-gloss featuring improved adhesion, superior exterior durability, gloss retention, excellent hardness (yet retains good flexibility for better checking resistance) plus good flow out and leveling for spray application.
Intended Use: For marine areas, metal substrates, machinery, white blasted steel, cold rolled or hot rolled steel, etched galvanizing, aluminum or primed wood surfaces.
VISCOSITY: 65-70 k.u.
DRY TO TOUCH: 10 minutes
WEIGHT SOLIDS: 36-48% depending upon color*
TACK FREE: 2-3 hours
VOLUME SOLIDS: 30-34% depending upon color*
TIME TO RECOAT: less than 2 hrs. or more than 24 hrs.
WEIGHT PER GALLON: 7.50-8.95 lbs. per gal.
DRY HARD: 8 hours
V.O.C.: 560 grams per liter
COLOR RANGE: White and Tints
FLASH POINT: 50° F.
PACKAGING: 1 or 5 gallon containers
PRACTICAL COVERAGE: 300-500 square feet per gallon depending on application.
* Contact Farwest Paint for specific weight solids and volume solids % for individual colors.
SURFACE PREPARATION: Surface to be coated must be thoroughly cleaned, sanded and primed. On Ferrous Substrates: All loose scale and rust should be removed before priming. A near white sandblast will provide the best surface for subsequent coatings. Aluminum: Must always be cleaned and etched before painting. Galvanized Steel: Should be thoroughly cleaned, etched, and primed with a zinc rich primer such as Farwest DOD-E-15328D Zinc Wash Primer.
APPLICATION: Apply by airless or conventional spray. It is possible to brush apply small areas by adding High-Flash Aromatic Solvent., but it is not recommended to brush apply larger areas. Primers should be lacquer proof type such as Farwest X-4985 White Lacquer Proof Primer or X-4959 Red Lacquer Proof Primer.
THINNING: Thin if necessary with Farwest #605 Synthetic Thinner. No thinning should be required for airless application. For conventional spray, a reduction of approximately 15-20% may be necessary for proper atomization and flow. Normally, a viscosity of 22" to 27" on a #2 Zahn Cup will produce the best results.
CLEAN-UP: Tools and equipment may be cleaned with Farwest #605 Synthetic Thinner, Farwest #615 Wash Thinner, or Farwest #610 Lacquer Thinner.
LIMITED WARRANTY. To the best of our knowledge, the technical data presented above is true and accurate at the date of issuance and subject to change without prior notice. Farwest Paint Manufacturing Co. guarantees its products to conform to its standards of quality control. Liability is limited to replacement of product. No other warranty or guarantee of any kind is made by Farwest Paint Manufacturing, implied or otherwise.