Government Spec.-Type Coatings

X-7214 & X-7215 Commercial Equivalent to
MIL-P-24441 Polyamide Green Primer (Formula 150)

COLOR(S): Green.

PRODUCT TYPE: 2-Component Epoxy-Polyamide.

DESCRIPTION: A two-component epoxy-polyamide with good resistance to solvents (except alcohols), salt spray, marine exposure and ordinary air pollutants. This product is approved for immersion service according to AAWA Inside System No. 1. The two components of this product must be mixed thoroughly one hour before using. It has self-priming qualities and one or two coats is recommended.

Intended Use: As a primer where excellent adhesion is needed on solvent-cleaned steel or for a marine environment protective coating.


VISCOSITY: 77-87 k.u. (mixed)

DRY TO TOUCH: 2 hours

WEIGHT SOLIDS: 69-71% (mixed)

TACK FREE: 3 hours

VOLUME SOLIDS: 52-54% (mixed)

TIME TO RECOAT: 24 hours

WEIGHT PER GALLON: 10.5 lbs. per gal. (mixed)

DRY HARD: 6 hours

V.O.C.: 337 grams per liter (mixed)


FLASH POINT: 100 F. (mixed)

PACKAGING: 1 or 5 gallon containers

BATCH: Stock

PRACTICAL COVERAGE: 250 square feet per gallon @ 3 mils dry film thickness.

SURFACE PREPARATION: When applied over primer, the primer should be clean, free from dirt and oil. New steel should be sand blasted to remove all mill scale. Solvent or power tool cleaning are satisfactory for atmospheric exposures and sandblasting is necessary if submerged service is desired.

APPLICATION: Airless or conventional spray. Roll or brush application are limited. A two-component system that is mixed just before using 1 Volume Component A to 1 Volume Component B. Induction time of one hour should be allowed before application.

THINNING: Not usually required but thin if necessary with industrial Methyl Ethyl Ketone. Maximum thinning is 10%.

CLEAN-UP: Tools and equipment may be cleaned with industrial Methyl Ethyl Ketone

LIMITED WARRANTY. To the best of our knowledge, the technical data presented above is true and accurate at the date of issuance and subject to change without prior notice. Farwest Paint Manufacturing Co. guarantees its products to conform to its standards of quality control. Liability is limited to replacement of product. No other warranty or guarantee of any kind is made by Farwest Paint Manufacturing, implied or otherwise.