FARWEST PAINT PRODUCT INFORMATION

Government Spec.-Type Coatings

TT-P-1046A Zinc Rich Primer

(Commercial Equivalent TT-P-1046A)

COLOR(S):Gray.

PRODUCT TYPE: Organic-Inorganic Zinc Rich Primer.

DESCRIPTION: A combination Organic-Inorganic Zinc Rich Primer supplied ready-mixed with Zinc Dust and Vehicle together. This product meets the performance requirements of MIL-P-21035, A-9-73 & TT-P-1046A. Its components are formulated to provide resistance to rust, weathering and heat and give better mechanical and chemical bond.

Intended Use: Primer on bare ferrous metals, for general marine use, bridges, steel pipes, chemcal plants (properly topcoated), architectural equipment and where there are severe atmospheric exposures when topcoated.

PHYSICAL CHARACTERISTICS

VISCOSITY: 88-92 k.u.

DRY TO TOUCH: 30 minutes

WEIGHT SOLIDS: 81%

TACK FREE: 1 hour

VOLUME SOLIDS: 42%

TIME TO RECOAT: 4 hours

WEIGHT PER GALLON: 21.85 lbs. per gal.

DRY HARD: 2 hours

V.O.C.: 486 grams per liter

COLOR RANGE: Gray

FLASH POINT: 50° F.

PACKAGING: 1 or 5 gallon containers

BATCH: Stock

PRACTICAL COVERAGE: 240 square feet per gallon @ 10% loss.

SURFACE PREPARATION: Good cohesion can be produced, if steel is cleaned properly and no rust exists. Sandblast according to SSPC specifications. Cold Galvanizing Repair: Clean surface with power tool or sand surface where damage has occurred.

 APPLICATION: Airless or conventional spray is the recommended application method. Airless tips should be approximately .027 inch orofice. Number of Coats: One at 2.3 mils DFT. May be topcoated with vinyl, chlorinated rubber, polyester or epoxy polyamide.

 THINNING: Thin if necessary with Farwest #605 Synthetic Thinner.

CLEAN-UP: Tools and equipment may be cleaned with Farwest #605 Synthetic Thinner or Farwest #615 Wash Thinner.

LIMITED WARRANTY. To the best of our knowledge, the technical data presented above is true and accurate at the date of issuance and subject to change without prior notice. Farwest Paint Manufacturing Co. guarantees its products to conform to its standards of quality control. Liability is limited to replacement of product. No other warranty or guarantee of any kind is made by Farwest Paint Manufacturing, implied or otherwise.